15 lines
894 B
Markdown
15 lines
894 B
Markdown
# Flying Bear P905H configuration
|
|
|
|
This configuration is for a P905H with **a single extruder and inductive Z-sensor**. It's been thoroughly tested, and I've tried to make the printer work smoothly, so this configuration is more focused on print quality than speed.
|
|
|
|
- Use this firmware as a baseline for other P905 modifications.
|
|
- Find other notes in the config files by searching for "P905H".
|
|
|
|
## Build Instructions
|
|
- Get Visual Studio Code and install the "Auto Build Marlin" extension.
|
|
- Download the [Marlin source code](https://marlinfw.org/meta/download/).
|
|
- Copy the two Configuration files from this folder into the 'Marlin' folder (replacing the existing files).
|
|
- Open the 'MarlinFirmware' project folder in Visual Studio Code.
|
|
- Click the "Auto Build Marlin" button and then the Upload button.
|
|
- Don't forget to reset your EEPROM with `M502` and `M500` after flashing.
|