44 lines
1.5 KiB
C++
44 lines
1.5 KiB
C++
/**
|
|
* Marlin 3D Printer Firmware
|
|
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
|
|
*
|
|
* Based on Sprinter and grbl.
|
|
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
|
|
*
|
|
* This program is free software: you can redistribute it and/or modify
|
|
* it under the terms of the GNU General Public License as published by
|
|
* the Free Software Foundation, either version 3 of the License, or
|
|
* (at your option) any later version.
|
|
*
|
|
* This program is distributed in the hope that it will be useful,
|
|
* but WITHOUT ANY WARRANTY; without even the implied warranty of
|
|
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
|
|
* GNU General Public License for more details.
|
|
*
|
|
* You should have received a copy of the GNU General Public License
|
|
* along with this program. If not, see <http://www.gnu.org/licenses/>.
|
|
*
|
|
*/
|
|
|
|
#include "../../inc/MarlinConfig.h"
|
|
#include "Delay.h"
|
|
|
|
void esp_wifi_init(void) { // init ESP01 WIFI module pins
|
|
#if PIN_EXISTS(ESP_WIFI_MODULE_GPIO0)
|
|
OUT_WRITE(ESP_WIFI_MODULE_GPIO0_PIN, HIGH);
|
|
#endif
|
|
#if PIN_EXISTS(ESP_WIFI_MODULE_GPIO2)
|
|
OUT_WRITE(ESP_WIFI_MODULE_GPIO2_PIN, HIGH);
|
|
#endif
|
|
#if PIN_EXISTS(ESP_WIFI_MODULE_RESET)
|
|
delay(1); // power up delay (0.1mS minimum)
|
|
OUT_WRITE(ESP_WIFI_MODULE_RESET_PIN, LOW);
|
|
delay(1);
|
|
OUT_WRITE(ESP_WIFI_MODULE_RESET_PIN, HIGH);
|
|
#endif
|
|
#if PIN_EXISTS(ESP_WIFI_MODULE_ENABLE)
|
|
delay(1); // delay after reset released (0.1mS minimum)
|
|
OUT_WRITE(ESP_WIFI_MODULE_ENABLE_PIN, HIGH);
|
|
#endif
|
|
}
|